|
#1
19-12-2002, 14:26
|
|||
|
|||
|
Executer 2 problem
I have recently purchased the Executer 2 modchip and i am having a few problems.
I have soldered all of the relevent wires into the correct points but when i apply the actual executer 2 chip the x-box fails to boot. It makes a strange beeping noise and has no picture. When i remove the executer 2 chip the x-box boots fine. I have tried the chip with the jumper both on and off and it has the same effect. Anyone have any ideas? 
|
| Sponsored Links |
|
#2
19-12-2002, 15:05
|
||||
|
||||
|
That ussually happens when a point isn't soldered right. Recheck all points, and make sure the ground point is soldered. Also, did that chip come preflashed with bios? I haven't checked it out yet.
__________________
--v1.0 [COLOR=Gray]case modded[/COLOR] Xbox with a [COLOR=DarkGreen]160gb[/COLOR] HDD upgrade[URL="irc://irc.efnet.net/fileforums"] [/URL]
|
|
#3
20-12-2002, 12:30
|
|||
|
|||
|
Also you should make sure that you have the proper bios on the chip, because some chips need to be flashed before usage.
Need mod chip installs? click here
__________________
"I'm the best at what I do, although what I do isn't very nice!!"
|
 |
|
|
Linear Mode
