Executer 2 problem
 

I have recently purchased the Executer 2 modchip and i am having a few problems.
I have soldered all of the relevent wires into the correct points but when i apply the actual executer 2 chip the x-box fails to boot. It makes a strange beeping noise and has no picture. When i remove the executer 2 chip the x-box boots fine.
I have tried the chip with the jumper both on and off and it has the same effect.
Anyone have any ideas?

That ussually happens when a point isn't soldered right. Recheck all points, and make sure the ground point is soldered. Also, did that chip come preflashed with bios? I haven't checked it out yet.

Also you should make sure that you have the proper bios on the chip, because some chips need to be flashed before usage.


Need mod chip installs? click here

The Executer 2 Lite is delivered with a BIOS.

this chip comes shipped with two bios and a jumper.
jumper closed xbox version 1
jumper open version 1.1
i made the same mistake when i fitted mine