Executor2

suggy · #1 13-02-2003, 13:25

Tryed to install Executor2 mod chip.

All that happens is , Beeping several times followed by red and green flashing light?

Any idears?

Quall999 · #2 13-02-2003, 13:57

Check yout solder points, or re-install it. That ussually happens when one of your soldering points are not touching the board completely.

#3 13-02-2003, 20:47

The chip may also be shorting out against the case check that also. Which do did you use top or bottum?

suggy · #4 14-02-2003, 00:59

Dont think any off them as i allready have a Evox chip installed (on pins)

xxlenigma · #5 14-02-2003, 04:07

See thats why I would like to get a premod xbox because I mite mess something up in there

suggy · #6 14-02-2003, 04:35

Havent messed up,
The chip (EvoX) works fine,
Just want some thing better,
Chip may be faulty its going back for a replacement

AXmichigan · #7 14-02-2003, 13:02

yea the same crap happened to me
im gonna resend it back
i just needa getta chance too....
im way too tired to do anything nowadays
i got mine from extreme-mods
...
accordin to www.xbox-scene.com it means that its a bad chip/bad image

suggy · #8 15-02-2003, 01:48

Mine from DIVINEO Electronics Manchester

AXmichigan · #9 15-02-2003, 18:21

i take it thats from UK
mines from the states...
so yea..
just send it back...
thats what i did
it better work wheni get it back

suggy · #10 16-02-2003, 04:45

I good old UK

It better work or the S**T will hit the fan

AXmichigan · #11 16-02-2003, 09:50

i agree
some major @$$ kickin if it doesnt work when it comes back