Executor2
 

Tryed to install Executor2 mod chip.

All that happens is , Beeping several times followed by red and green flashing light?

Any idears?

Check yout solder points, or re-install it. That ussually happens when one of your soldering points are not touching the board completely.

The chip may also be shorting out against the case check that also. Which do did you use top or bottum?

Dont think any off them as i allready have a Evox chip installed (on pins)

See thats why I would like to get a premod xbox because I mite mess something up in there :(

Havent messed up,
The chip (EvoX) works fine,
Just want some thing better,
Chip may be faulty its going back for a replacement

yea the same crap happened to me
im gonna resend it back
i just needa getta chance too....
im way too tired to do anything nowadays
i got mine from extreme-mods
...
accordin to www.xbox-scene.com it means that its a bad chip/bad image

Mine from DIVINEO Electronics Manchester

i take it thats from UK
mines from the states...
so yea..
just send it back...
thats what i did
it better work wheni get it back

I good old UK

It better work or the S**T will hit the fan

i agree
some major @$$ kickin if it doesnt work when it comes back