|
#1
19-12-2002, 03:51
|
|||
|
|||
Question for an expert ;)
Hello,
I have a problem with my magic 2 V7 (with clip v2.1 pitch 1.25) i have just installed on a scph-39004. PS1 backups and originals boot (prosedure : from standby I push reset until blue flashes). PS2 originals boot but with the PS1 booting procedure decribed above ! PS2 backup don't boot (black screen after the "electrons"). So I have questions: 1) Can you give me your magic 2 boot procedure. Perhaps mine is wrong ! 2) During the installation, I didn't know what to do with a blue wire in the middle of the BGA cable (magic chip side) because i had no information on the installation diagram (magic 2v7 + clip v2.1). What's wrong ? 3) What king of test I can do to check this installation ? Thanks a lot for your help. By. 
|
| Sponsored Links |
|
#2
19-12-2002, 06:10
|
||||
|
||||
|
Here is the boot procedure for the Magic 2..
NOTE: This is with the disk assumed in the tray and the tray closed: Playstation 2 games •Power up normally from STANDBY with RESET button. A single tap of the reset button is required. Playstation 1 games & DVD Movies •Power up from STANDBY with RESET button held until the blue EJECT light comes on. •Then release RESET and the disk will boot. NOTE: Turn off the PS2 (to standby) before changing Modes (PS1/PS2/DVD)
__________________
[COLOR=blue][B]**V5 PAL** SCPH-30004 R W/[/COLOR][COLOR=red]Messiah[/B][/COLOR][b][color=blue][/b][/color] [color=blue][b]**V7 NTSC** SCPH-39001 W/ [/color][color=red] Messiah 2 [/color][color=blue](Installed by My M8: [/color][color=red]Dust2Dust[/color][color=blue])[/color][/b] :) [COLOR=blue][B]Pioneer DVR-A05 [/color][color=red] (FW 1.30) w/2X Ritek hack![/color][/b] :D [b][color=blue]Lite-On LTD-166S DVD-Rom W/[/color][color=red]Smart-X[/color][/b] [COLOR=blue][B]LG GCE-8320B W/[/color][color=red]8MB Buffer[/COLOR][/B]
|
 |
|
|
Linear Mode
