CloneDVD2 v2.0.4.1 Doesn't Finalise Burn

[Mickle]

I am currently using CloneDVD2 v2.0.4.1 (with AnyDVD) to backup my DVD collection. Up until about a month ago, it was working fine. Now when I burn, it reads and writes with no problems, however after flushing buffers etc. it just sits there on 100% but will not close. I have to restart computer to retrieve the disc.

It usually plays ok in my XBox, but often goes straight into the movie without showing menus. Occasionally the DVD will freeze a couple of minutes before the end. I had been using cheaper discs, but I've continued to have the same problems since changing back to good quality -Rs.

Any help would be greatly appreciated. Thanks.

[TylerDurden]

Consider upgrading your CloneDVD2 since there have been quite a few updates since your version.

Look for yourself, http://www.elby.ch/en/products/clone_dvd/revision.html


Then I would also consider checking for firmware updates for my burner.





Tyler!