|
#1
31-07-2003, 19:50
|
||||
|
||||
|
Serious Help Needed
Hey i am running a Version 7 ps2 chipped with a magic3..It has worked flawlessly until now when i tried to put a switch in... I scred sumthing up so i pulled it all out!! now when i start my ps2 nothing happens...The greeen lite goes on but the blue lite wont go on
i checked all wires/ribbon cables!!! Any ideas?
__________________
[COLOR=DarkGreen]PS2 v5/Crystal chip and 15hacked firmware[/COLOR] [COLOR=DarkSlateGray]Halo le.. X3, X3 proswitch, XLCD,2 usb ports, Green controller ports [/COLOR]--->[SIZE=5][COLOR=Red]FOR SALE!![/SIZE][/COLOR] [COLOR=DarkGreen]V1.0, X3, XLCD, proswitch, blue lights all over[/COLOR] 
|
| Sponsored Links |
|
#2
01-08-2003, 10:09
|
||||
|
||||
|
if this is how it acts after removing the chip...
- make sure there is no damage done to the ps2 on any of the connection points (or anywhere else for that matter) - make sure there is no bridging on the bios chip, use desoldering braid to clean the chips legs - if all looks good on the motherboard you might have blown a fuse. to fix this you just need to find the blown one and replace it. to find the blown fuse simply use a multimeter (set a 200 ohms). the reading you get should be between 0 and 0.3 ohms anything else is a blown fuse. a list of fuses can be found here (you might need to register)
__________________
[color=blue][b]- NTSC PS2 v7 with Messiah2[/b][/color] [color=blue][b]- NTSC PS2 v7 with Messiah2 and 120gig Maxtor[/b][/color] [color=blue][b]- NTSC XBOX v1.4 with 120gig Maxtor[/b][/color] [color=blue][b]- Pioneer DVR-A05[/b][/color]
|
 |
|
|
Linear Mode
