|
#1
10-06-2003, 23:49
|
||||
|
||||
|
PSone classic mod chip
just a few ?'s on the PSone mod chip classic dose any one know were to get a good dirgram for this chip they got one at gocyber but the chip sows to have for soldering wires but yet the digram only shows 3 spots to solder and also could i use the stelth digram on this chip or r they diferent?
|
| Sponsored Links |
|
#2
11-06-2003, 10:36
|
||||
|
||||
|
dose any one here know were i can get a diagrm for this chip on a spch 101 system only one i found was at go cyber but it shows 4 wires on the chip but only had 3 solder points so what would the 4th wire which is black be used for ?
|
|
#3
12-06-2003, 07:59
|
|||
|
|||
|
OK, I think the old 4 wire chips only need 3 wires in PSX 101’s and 9001’s , pins 1, 8, and 6. The pin 5 of the 4 wire mod is not compatible with these boards. The chip will work but it will only boot BACKUP CD’s and not original games. The 9001 had a jumper wire you could add to the board in place of pin 5 to fix original CD booting, the 7501 board as well, I think. I don’t know of any jumper for 101’s.
All that is fixed in newer chips. Have a look at these diagrams: http://www.modchip.com/pictures.htm All points for pins 1,8,5,6 should be pretty much the same no matter what chip, the 2 or 3 extra points are ONLY for the stealth mode.
|
|
#4
12-06-2003, 08:52
|
||||
|
||||
|
ok so i think i will try and buy a stelth chip they seem easier to install then the clasic chips cause the digrams that r made 4 the classic chip show theres 4 wires on point 1 5,6,8 and the solder diagram to solder to the board is only useing the 1,5,6, wire and the 8, wire which is black is not begin used and 6 has a jumper wire on it so i tryed it this way didnt work and i found another web site with a digram for classic chip shows all 8 wires to solder tryed this way ad dont work eather so i think i will just get a stelth they seem to be easier to install then these
|
|
#5
12-06-2003, 09:10
|
||||
|
||||
|
i went ahead an order a stelth IV it says there made just for the mini psones and they look alot easier to install then the classic dont have to have jumpers or any thing and the diractions look easier to understand
|
 |
|
|
Linear Mode
