|
#1
02-05-2003, 21:18
|
|||
|
|||
|
need help
Got my mod chip today its an x2lite+ with pogo pins built in and Im going to go crazy if I dont get it lined up soon("do" point) Ive tried to line it up about 25 times now with no luck. I cant solder so thats out oif the question and I cant even try because i dont have a solder gun. Is the any tips anyone can give me? This thing is driving me to a point where Im about to break! it really doesnt even seem like it lines up real good. Is there anything I can put on the do point to make it bigger like a ball of wire or something I know it sounds crazy but Im about to run out of patience!
|
| Sponsored Links |
|
#2
02-05-2003, 22:37
|
||||
|
||||
|
First question, what Ver XBox do you have?
__________________
[SIZE=1]NTSC Ver1.0 XBox w/ [URL=http://www.gameshopusa.com/]X2.3 Lite[/URL] flashed with X2 4981.06 120GB WD 7200RPM 8mg cache Samsung SDG-605B * All stuffed in a beautiful translucent green case UK PAL Ver1.4 XBox ([i]not chipped yet[/i]) Stock 8gb WD Philips 6035/21 * All stuffed in a beautiful Crystal Clear case[/SIZE] [I]Having a BMW that says “Made in the USA” is like having a Rolls-Royce that says “Made in Japan”[/I]
|
|
#3
02-05-2003, 22:46
|
||||
|
||||
|
This mite help you. X-ecuter II Lite & Pro PogoPin Modchip diagrams
__________________
[SIZE=1]NTSC Ver1.0 XBox w/ [URL=http://www.gameshopusa.com/]X2.3 Lite[/URL] flashed with X2 4981.06 120GB WD 7200RPM 8mg cache Samsung SDG-605B * All stuffed in a beautiful translucent green case UK PAL Ver1.4 XBox ([i]not chipped yet[/i]) Stock 8gb WD Philips 6035/21 * All stuffed in a beautiful Crystal Clear case[/SIZE] [I]Having a BMW that says “Made in the USA” is like having a Rolls-Royce that says “Made in Japan”[/I]
|
|
#4
02-05-2003, 23:05
|
|||
|
|||
|
its a version 1.0 sorry for not adding that Ive looked at the diagrams but this chip doesnt seem to actually line up correct. Its like when I try to line up the "do" point the chip needs to be back a little then it pushes the screw back so then when I tighten the screw down i pushes the pin on "do" piont forward off the "do". hopefully you can understand what Im trying to say. Thanks in advance for replies
|
 |
|
|
Linear Mode
