|
#1
24-10-2002, 11:05
|
|||
|
|||
|
Removing Chip
I bought a premodded PS2 Magic 2 and still can't get it to work with the copied games. I have tried all the suggested tricks such as holding the reset button. I think I am going to remove the chip from the system.
Two questions before I do this. Any last minute suggestions on what I might be doing wrong? The copies work on my modded PS but not the PS2. Some were copied with NERO and some with CloneCD. Second, if I remove the chip, can I just cut the wires without it effecting the system or do I have to unsolder the chip? 
|
| Sponsored Links |
|
#2
24-10-2002, 15:48
|
||||
|
||||
|
If you BOUGHT a pre-modded system....
WHY WOULD YOU REMOVE THE CHIP!!!!!! Send it back to who you bought it from.... Make them fix it....
__________________
[COLOR=blue][B]**V5 PAL** SCPH-30004 R W/[/COLOR][COLOR=red]Messiah[/B][/COLOR][b][color=blue][/b][/color] [color=blue][b]**V7 NTSC** SCPH-39001 W/ [/color][color=red] Messiah 2 [/color][color=blue](Installed by My M8: [/color][color=red]Dust2Dust[/color][color=blue])[/color][/b] :) [COLOR=blue][B]Pioneer DVR-A05 [/color][color=red] (FW 1.30) w/2X Ritek hack![/color][/b] :D [b][color=blue]Lite-On LTD-166S DVD-Rom W/[/color][color=red]Smart-X[/color][/b] [COLOR=blue][B]LG GCE-8320B W/[/color][color=red]8MB Buffer[/COLOR][/B]
|
|
#3
24-10-2002, 19:46
|
|||
|
|||
|
BG THIS IS WAY (REMOVE CHIP)
I think the chip and install are fine. Either I am doing something wrong or the burn format is not correct for this chip. If I send it back I now they will say it works fine and bill me for all the shipping back to Canada and back to me again. I put so much money into trying to get this to work right it is no longer worth it. I only play about 3 different games and I have all them in original. If I pull the chip and sell it at least I can recoup some money.
PS The place I bought it was www.gocybershop.ca There service dept sucks. They basically told me it worked when it left their shop. I emailed asking for assistance with getting copies to work (as their website says) and they said copies were illegal and they couldn't help me. So then I asked for assistance with "backups" and they won't even return my emails.
|
|
#4
24-10-2002, 20:13
|
||||
|
||||
|
Send me a e-mail.... I may send you a "know good" working backup of a PS2 cd based game and a PS1 game... At least this way we can be SURE if its the chips fault or your burnings fault...
[email protected] Of course, these would be for "TESTING" purposes only.... Send me a e-mail and I will see what I can work out...
__________________
[COLOR=blue][B]**V5 PAL** SCPH-30004 R W/[/COLOR][COLOR=red]Messiah[/B][/COLOR][b][color=blue][/b][/color] [color=blue][b]**V7 NTSC** SCPH-39001 W/ [/color][color=red] Messiah 2 [/color][color=blue](Installed by My M8: [/color][color=red]Dust2Dust[/color][color=blue])[/color][/b] :) [COLOR=blue][B]Pioneer DVR-A05 [/color][color=red] (FW 1.30) w/2X Ritek hack![/color][/b] :D [b][color=blue]Lite-On LTD-166S DVD-Rom W/[/color][color=red]Smart-X[/color][/b] [COLOR=blue][B]LG GCE-8320B W/[/color][color=red]8MB Buffer[/COLOR][/B]
|
|
#5
24-10-2002, 21:06
|
||||
|
||||
|
Magic 2 Booting
NOTE: This is with the disk assumed in the tray and the tray closed: Playstation 2 games •Power up normally from STANDBY with RESET button. A single tap of the reset button is required. Playstation 1 games & DVD Movies •Power up from STANDBY with RESET button held until the blue EJECT light comes on. •Then release RESET and the disk will boot. NOTE: Turn off the PS2 (to standby) before changing Modes (PS1/PS2/DVD)
__________________
[COLOR=blue][B]**V5 PAL** SCPH-30004 R W/[/COLOR][COLOR=red]Messiah[/B][/COLOR][b][color=blue][/b][/color] [color=blue][b]**V7 NTSC** SCPH-39001 W/ [/color][color=red] Messiah 2 [/color][color=blue](Installed by My M8: [/color][color=red]Dust2Dust[/color][color=blue])[/color][/b] :) [COLOR=blue][B]Pioneer DVR-A05 [/color][color=red] (FW 1.30) w/2X Ritek hack![/color][/b] :D [b][color=blue]Lite-On LTD-166S DVD-Rom W/[/color][color=red]Smart-X[/color][/b] [COLOR=blue][B]LG GCE-8320B W/[/color][color=red]8MB Buffer[/COLOR][/B]
|
 |
|
|
Linear Mode
