Turning Mod chip off

[Big Al]

Question: Is it possible to turn off my existing mod chip?

Can I just disconnect it and then reconnect it?

Any help would be great.

Big Al

what you can do is install a toggle switch inline on the (pos) pin

R-dude (17-01-2001 03:26):
what you can do is install a toggle switch inline on the (pos) pin

Accidentally made a new post. Anyways here it is
-----------------------------------------------
I asked how to explain and heres one of the replies I had gotten. Hope this helps.

------------------------------------------------
Just to add to spookys solution, you need only cut EITHER the wire at pin 1 OR at pin 8 as these are the wires that power the chip (1=V+) (8=V-), then put the switch in between the two pieces of the wire you have cut.
As I have tried to demonstrate below !!!!!
.......................\.......................... ......
to pin<_______|---|______>to spot on PCB
switch

------------------------------------------------