TDK 121032a / CloneCD Write Error

I just upgraded my system to;
- Epox 8k7a+ with Highpoint RAID Controller
- 2 x WD 40 GB Hard Disk Drives (RAID 0)
- Toshiba 48x CD
- TDK VeloCD 121032a (with jumper for sub channel)
- CloneCD (latest version)

When I go to create the image, the Toshiba reads no problem, but when it switches over to write, it errors out with a Write error after clearing the buffers. I am at a loss and looking for any suggestions?

[SW-212B]

I experienced the same problem with you till i changed the software.Try using discjuggler.It rarely causes such errors

[Wayniac]

I used numerous versions of Discjuggler, and only had success by using the latest version:

v3.00.755-FTU

However this doesn't mean to say you won't be able to use an older version.

All the best :-)

I slowed the CDRW down to PIO4 and removed the sub channel data fix off the back of the CDRW and now everything is fine. IMHO, it looks like a VIA IDE busmaster driver issue.

Thanks for all of the suggestions.