|
#1
17-11-2000, 05:54
|
|||
|
|||
|
CDRWIN Copy Question
I am using CDRWin to create an image of a PSX game, but when I try to use the game, no go. Are there specific settings I should be aware of when creating the image?
|
| Sponsored Links |
|
#2
17-11-2000, 07:13
|
|||
|
|||
|
at first you have to burn the image
 just kidding, most psx games need patches befor you burn them. if you burn the image witout patching it dont will be playable on a psx. excuse my german school english hehe ps.: do you have a chip in your psx? otherwise a burned cd dont work on a psx
__________________
why didnīt work this shit AARRGHH
|
|
#3
17-11-2000, 08:54
|
|||
|
|||
|
1st make sure u have a good key number, if not then CDRWin burns coasters. Secondly have all programs in u'r task bar turned off (including anti virus progs). I personally never even use the pc when it's burning either.
B4 u burn check on one of the sites to make sure that the game isn't copy protected, if it is u'll have to patch the image u'v burnt. Another thing is to set the parameters in the reading section to ensure that it ignores errors. I don't know this guy but if u check out his site it has a FAQ on CDRWin http://freespace.virgin.net/darren.fowles
|
 |
|
|
Linear Mode
