|
#2
11-07-2005, 16:20
|
||||
|
||||
|
nah, multimeters are ok, just use a low resistance test, and you'll be fine. (if the 2 points are isolated completely, you'll see 0, and it will react if and then go to 0 if there is a direct connection, and if there is high resistance {like between 2 pins of an IC} then you will get a reading for the resistance) it should just be the BIOS chip that you have the most problems with, am i right?
dont worry, i was in the same boat as you a while ago, im a horrible solderer. i just went in the "post your mod pics" thread and found one for a V7 infinity, and copied it directly, and it worked like a nut 
__________________
====ROCK STEADY==== Last edited by oZER0o; 11-07-2005 at 16:23. 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Matrix Infinity and PAL games on a NTSC system | p2501 | PS2 Games | 1 | 27-05-2005 21:07 |
| Matrix Infinity Chip Firmware | A03 | PS2 Games | 1 | 21-02-2005 22:39 |
| Problem with Infinity chip | xSAVAGEx | PS2 Games | 7 | 07-12-2004 20:30 |
| matrix infinity v7 install - question | err0r | PS2 Games | 6 | 10-11-2004 23:53 |
| Matrix Infinity 1.3 Coming This Weekend? | lufcfan | PS2 Games | 15 | 27-09-2004 10:42 |
Threaded Mode