HELP... please... please... whimper...

I'm going crazy trying to figure this all out.

X2.3B Lite +, installed fine.
X2_4283, flashed fine.
160GB HDD, installed fine.
F: & G: partitions... trouble. And lots of it.

F: only registers around 25GB and G: registers 0GB.
I don't get it.

Someone, please help.

Pathetically,
monkeyshare

[Quall999]

What did you use to format f (and G if u have the 67 bios)?

I altered a evox.ini file to "configsector", format c: - format z: etc. Is there another utility that I should have been using?

Thank you for replying, by the way...

[Quall999]

i've only dont it in evox via ftp, but I will say that I have never formated x, y , or z. They appeared automatically. Try reformatting the F drive, since that is the only partition with a problem at the moment.

Which bios are yo using, 06, or 67?

HAHA, it never stops... just had a bad flash. Waiting on the external flasher/programmer to arive. I feel like an idiot.

I'll try that, just formatting F:.

And I was using a .67 X2 bios. But after everything arrives, I'll give your suggestions a try.

Thanks.

[Quall999]

well, if you only have a 160gb drive, I would suggest using the 06 bios. That way, all your data will be on 1 drive instead of a 137gb F, and a 15gb G.