Xecuter 2.3 needs to have a controler plugged in

Dobie1 · #1 18-12-2003, 05:43

I was just modding out a few boxes for friends for gifts. the v2.3 chips get their power from the USB port (where the controlers plug into the MB).

For some reason you need to have a controler plugged into the port or the mod chip will not get power, and thus not boot.

Not all that big of a deal - but just something that caused me a little bit of a headake until I figured it out.

Quall999 · #2 18-12-2003, 06:13

lmao, i never looked at the install directions, but if that's the case then the circuit is not completed with the controller unplugged. I find this very funny lol. Also find it wierd that they did it that way.

rms2001 · #3 18-12-2003, 12:03

Quote:

For some reason you need to have a controler plugged into the port or the mod chip will not get power, and thus not boot.

I installed two X2.3 Lites last week, I never had to have a controller plugged in to get the chip to light up and the XBox boot.