|
#8
05-12-2003, 19:55
|
||||
|
||||
|
Hey EvoEvo, just an ole trick of the trade, if the iron tip is too big.
I believe you can take it to a grinder and tone it down a bit then get it hot again and dip it in melted solder, and shake off the excess. thus giving you a finer tip to work with. should make it easier for persicion jobs in the future. (if you didnt already know this) Hope your v9 is Ok man. Let us know... Happy Holidays dude
__________________
[B]may the best of your past, be the worst of your future......:cool: ....[/B] 
|
|
|
Threaded Mode