|
#1
02-10-2003, 15:24
|
|||
|
|||
|
will moving laser cause disk read errors
I just bought a new ps2 v7 had a shop solder a dms3 chip in it. While taking of the dvd-rom cable i felt the laser move. Now i am getting disk read errors.
Would moving the laser cause this? Last edited by swzgriz; 02-10-2003 at 17:42. 
|
| Sponsored Links |
|
#2
02-10-2003, 19:53
|
||||
|
||||
|
Ok wait a min here. Whats broke your Eject or your Laser? Or both?
Tyler!
__________________
[B]V7 Ps2 Messiah 2 V13 PSTwo DMS4 Pro and HD-Connect(Installed myself)[/B]
|
|
#3
03-10-2003, 04:16
|
||||
|
||||
|
if a shop fitted it why the hell he taking dvd cables off????
__________________
Zap Brannigan quote - "You remind me of a younger me Fry, Not much younger mind, perhaps even a little older."
|
|
#4
03-10-2003, 16:33
|
|||
|
|||
|
i took the motherboard out and removed the cable from the dvd and just brought the board in. When I first put the board back in the ps2 eject was not working when the ps2 was turned on first.
but when you pressed eject when it was off it would open. Then i took out the board out and checked the wires. when i put it back in the eject worked but it will not read disk.
|
|
#5
03-10-2003, 19:29
|
||||
|
||||
|
take it apart completely and put it back together more carefully and slowly.
Sounds like another loose lead. Regards
__________________
Zap Brannigan quote - "You remind me of a younger me Fry, Not much younger mind, perhaps even a little older."
|
 |
|
|
Linear Mode
