No solder eject problem

zcx · #1 05-08-2002, 22:20

I just got a no solder mod v4 off of consolesource.com and installed everything correct and it boots up but the eject button dosent work, dose anyone know how to solve this?

filippos · #2 06-08-2002, 02:24

Give more info. Specification of your console, chip, boot cd, and the method you follow to boot it. Are you sure a professional installed the chip because if yes then he should explain to you how to boot it.Give the excact steps you follow inorder to run your buckup and maybe someone can help you.

zcx · #3 06-08-2002, 08:01

Quote:

Originally posted by filippos
Give more info. Specification of your console, chip, boot cd, and the method you follow to boot it. Are you sure a professional installed the chip because if yes then he should explain to you how to boot it.Give the excact steps you follow inorder to run your buckup and maybe someone can help you.

No, I did it myself and i know its correct, and everyone knows if you have the no solder v4 you need a GS2 to boot the CD.

D Soldier · #4 06-08-2002, 09:25

try pushing the chip in more, or maybe the eject cable came out. It took me a long time to figure out that the chip wasn't pushed in all the way

zcx · #5 06-08-2002, 12:29

Quote:

Originally posted by D Soldier
try pushing the chip in more, or maybe the eject cable came out. It took me a long time to figure out that the chip wasn't pushed in all the way

I pushed it in as far as i could get it.

FreeEnima? · #6 06-08-2002, 13:09

are you sure you didn't fuck up the wire runnin from the eject button to the machine???did u bend it?

zcx · #7 06-08-2002, 13:53

Quote:

Originally posted by FreeEnima?
are you sure you didn't fuck up the wire runnin from the eject button to the machine???did u bend it?

You mean the ribbon? yes a little tiny bit it is bent.

NightStalker · #8 06-08-2002, 14:35

If the eject button doesn't work then the mod is useless. You must be able to press and hold eject to preform the R-mod swap. This cannot be done by GS2 or remote and be expected to work. The problem is either the ribbon cable or the mod. I have seen alot of PNP no solder mods with this problem so the first thing i would do is to remove the mod and see if it will eject. If it does then it's a bad mod or the contacts didnt make a good connection when the mod was installed. If it still doesn't eject after the mod is removed then i would suspect the ribbon cable.

zcx · #9 06-08-2002, 18:15

Quote:

Originally posted by NightStalker
If the eject button doesn't work then the mod is useless. You must be able to press and hold eject to preform the R-mod swap. This cannot be done by GS2 or remote and be expected to work. The problem is either the ribbon cable or the mod. I have seen alot of PNP no solder mods with this problem so the first thing i would do is to remove the mod and see if it will eject. If it does then it's a bad mod or the contacts didnt make a good connection when the mod was installed. If it still doesn't eject after the mod is removed then i would suspect the ribbon cable.

damnit are you sure backups wont work if i use a remote because i just ordered one.