Shogun Total War 2 for 2dvd9 3dvd5 by inno

[KillerOh]

So... in single steps:

1. Unpack the .SID files from RETAIL disks with Phoenex
(Unpacking additional languages are optional)

2. Install the patch mentioned above (I admit, i didn't understand PROPERLY the steps -14 and -15)
Or even aplying "skidrow" patches (I know, it's "Jack Sparrow's", but they aren't "Already cracked updates") without the "Anti-protection, Steamless measures"

3. Create a installer, either by:
- Creating a single, "lame" one with InnoSetup, or take the code from previous Peterf1999's InnoSetup installer (Or even some "Russian" nice-looking ones), modify them to your needs (Isn't Shogun Total War 2 a GFWL game, is it?) then compile
- Or InstallShield it. =X

4. Then

...





Sounds easy to me. =)

[car_l30n]

you will instead create an installer over the game ripped or installed after I used the (inno setup)...

here's the file's ready (inno setup) just install the (inno setup) and run the.


after conversion of innosetup create 3 folders
DISK1
DISK2
DISK3

move the following files from the shog (C: \ shog) for each specific folder

DISK1

setup.exe
setup-1a.bin
setup-1b.bin
setup-1c.bin
setup-1d.bin

DISK2
setup-2a.bin
setup-2b.bin
setup-2c.bin

DISK3

setup-2d.bin
setup-3a.bin
setup-3b.bin


download the files below autorum specific to each DVD or create them you msmo
and later add their folders DISK1, DISK2, DISK3

burn the dvds with the same folders of label

sorry the confusion is that I am a layman in making tutorials ... thanks