DMS4 EZI PRO/ LITE - any Good ?

[oZER0o]

yes, youre all right, ive been looking around the net and everyones complaining about these EZI chips. i respect your opinions, and im thankful for it, I've just got a hehe, a few cashflow problems

ok, forget EZI. and yes, I know i could get that V4 working, and could even sell it and make a few bob back after paying for my chip install.

It's just dawned on me that Computer Fairs always have modchippers, in fact, up here in newcastle, theyre crawling with them, and im going to a big one at gateshead stadium on Sunday. I'm going to take my PS2 in, and We'll see what happens there.

I have now realised that soldered chips are pretty much the mac daddy. i just dont want to pay 20 quid to post my PS2. anyway, thanks for steering me in the right direction. if this Nitex fair results unfruitful, mod-chip.com has given me a few places i can look for Newcastle Modders.

[oZER0o]

ok, ive done it myself ! lol im on the last wire. everything is perfect so far, ive checked everything with my multimeter. it seems that pins 15 and 16 of the BIOS chip have been bridged somehow, i think theres a bit of solder lodged dow inbetween the IC pins.

I'm very proud of myself actually, its a fairly neat job! this last wire is going to be a b**ch though. its V on the matrix infinity, and ive already done R. I'm going to have to un-bridge V and the pin next to it (not R, the pin on the other side) before i put the wire on. UGH. im too tired now, i'll do it tomorrow after college.

[Sun Ce]

I have an DMS ezi pro and i did the install on a v7, first time installer and it went in first time.
I was nervous as hell at first, but no probs what so ever and yes you do have to real careful on the install.

[oZER0o]

Originally Posted by Sun Ce

I have an DMS ezi pro and i did the install on a v7, first time installer and it went in first time.
I was nervous as hell at first, but no probs what so ever and yes you do have to real careful on the install.

too late ive already done the soldered install, im still at the same point as the above post.

[oZER0o]

ok, i FINALLY broke the solder bridge i did by accident, the multimeter is now giving a very high resistance between the pins. YAY! im just about to plug in me soldering iron to put those last 2 pesky wires in

[oZER0o]

done! just flashed the chip with firmware 1.5, and ive tried everything, ps1 games, ps2, backups movies, it all works PERFECTLY ! I'm completely chuffed with myself!

i would have taken a pic, but i dont have a camera. it was a fairly neat job by my standards as well

well im off to do some serious gaming dudes, ciao.

[spedmetal]

Good job man! Good job!