Magic 3 Problem

[Ernieboy0021]

Hej,

Got this type in my Playstation http://www.ps2reality.net/uploads/do...5/image009.jpg don´t know whats the difference between cable and ribben (U know my English )

So i will check now what is a multimeter? How can I get out if the flow is right? SO could it be that the reset/eject buttons aren´t working because the wire @ the chip?

thx 4 ya help

/////

EDIT: So checked what a Multimeter is and Hell Yeah, i´ve got a Multimeter! I use this to adjust the laser! ... So , and how can I check now if the flow is right? I mean this Multimeter will show it in Ohm´s or? How many Ohm´s must it have? And where should I put the + side and the - side???

[Warlock]

Sad to say but if its a v3 its probably not worth fixing. If you had to adjust the laser to read originals then it probably wont read dvd-r media period.

[seaneyb2003]

yeah, if you can fix it just sell it on ebay. right get a cable there be very cheap. But look along to see if u did snag it.

Right set your multimeter to read volts! its the V symbol on it and just check the psu to see if there is any current flowing.

might be worth it, its up to you.

[ihaveanosebleed]

I had a PS2 here once that someone had destroyed the Power/Eject ribbon and what I did was look through my junk room of parts and I found a ribbon from a printer that was twice as long and five times as wide. The contacts were the exact same size so I just cut the ribbon to the right width and plugged it in the PS2, it worked great. Beats spending money and waiting a week for the replacement part!

[Ernieboy0021]

Yeah, but i ain´t got an old printer?! (What type of Printer was this? *lol*)

So I soldered on the less wire on my chip! And I controlled my eject/reset ribbon again , I saw that there is a contact damaged.. so i soldered on it *gg* It works fine, .. hmm.. the one and only problem is now, that the red light (reset) didn´t light, it´s everytime green *gg* So i tried the PSX if it´s working and what was the result??? : If I start booting up my playstation it everytime resets itself *lol* So i´ve had to unsolder the ribbon and solder it again exactlier! *gg*

[ihaveanosebleed]

I think it was from an Epson 580 (?) Not too sure as I rip the guts out of these junkers and trash all the cases to save space. Or was it from a flatbed scanner?! I don’t remember for sure!

[seaneyb2003]

well it sounds like half the battle is won! what i would do now is resoder the reset wire on the modchip, and buy a new eject reset wire.

http://cgi.ebay.com.au/ws/eBayISAPI....sPageName=WDVW

[Ernieboy0021]

Nope, don´t have 2 buy reset/eject cable! My mom works in a company which developes IC-Plates (?is it this?U know my english?) she have got 1000kg of the same cables, just have to cut something! Today i´ve gonna try my PSX .. i hope it works!! Thx 4 everything

[seaneyb2003]

go for it man