|
|
|
#1
23-09-2004, 17:35
|
||||
|
||||
|
The lanquer is coat that covers the board to prevent a short circuit. Remember that current is running throught the board and humidity, water or any conductive substance will short out your board. The reason you scrape it off is to make a good contact when you solder.
__________________
JPunisher 
|
| Sponsored Links |
|
#2
23-09-2004, 18:32
|
|||
|
|||
|
lol ok well, i think i just did the most ghetto VIA install anyone has done. one wire stuck to the via no prob, so i connected it to the chip, the rest of the 3 wires. i just stuck it in the whole, slapped electrical tape on it and tested it with a multi meter.
with the multi meter i tested one chip leg point and a point on the matrix, it seems there is full connection. lol. so if i tested the chip leg while the wires are on the vias, and it made a good connection... must mean there is no laquer on mine.
|
|
#3
24-09-2004, 13:23
|
||||
|
||||
|
That's gonna cause problems dude, if you can't do them, get someone who can to do them...
__________________
[SIZE=3][COLOR=orange][B][COLOR=blue]PS2, [/COLOR][COLOR=yellowgreen]XBOX[/COLOR] & [COLOR=darkolivegreen]Xbox 360[/COLOR] installs / repairs in [U][COLOR=red]West Yorkshire,[/COLOR][COLOR=red] UK[/COLOR][/U] - [COLOR=#ff0000]Nationwide Service [/COLOR][COLOR=darkorange]-[/COLOR]Please Contact me by PM for more info[/B][/COLOR][/SIZE] :) [B][SIZE=4][COLOR=#ff0000][COLOR=seagreen]360 DVD Drive Fw.[/COLOR] [COLOR=orange]Upgraded/Recovered/Restored -[/COLOR] Bad Flash? No Problem! [COLOR=blue]PM for info[/COLOR][/COLOR][/SIZE][/B] [B][SIZE=4][COLOR=#ff0000][COLOR=yellowgreen]XBOX 360[/COLOR] [COLOR=blue]v1.0[/COLOR] [COLOR=blue]- [/COLOR][/COLOR][COLOR=red]Samsung TS-H943A [COLOR=orange]w/ iXtreme 1.4 Fw.[/COLOR] :D [/COLOR][/SIZE][/B]
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Hybrid Mode
