|
#4
06-02-2004, 23:35
|
||||
|
||||
|
The first thing I would tell you to do would be to move that chip off the ground plane! Where you have it the heat/RF shield I'm sure could be shorting out those pads on the chip its self. It’s obviously on a V5/V6 board. If there was no sticker on the chip you have the right chip most likely. The install looks pretty good other then where you put the chip. If you have a continuity checker check point T and the pad right next to it, it looks like there is a bridge....might just be the picture though. Do all that first then get back to use. There is more that could be the problem.
__________________
[color=blue][size=2][b]Click[url=http://www.ps2-scene.org/forums/showthread.php?t=25770] here [/url]to view refes. Click[url=http://www.norcalmods.com/gallery] here [/url]to view install gallery[/b][/size][/color] [size=2][b][color=red]Mod chip installs and repair [/color][/b][/size] [url]www.norcalmods.com[/url] Last edited by spedmetal; 07-02-2004 at 00:46. 
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Threaded Mode