|
#7
22-10-2003, 16:42
|
||||
|
||||
|
Pin 4 monitors the reset button, pins 5, and 6 open and close the tray. Could be that a wire came loose or the chip is grounded but i doubt it. Also i wouldnt waste my time replacing the laser then rechipping it if its older than a v5. I would clean it up, get it loading originals fairly ok and sell it. Then buy a premodded unit or just get a new console along with a ApplePro or messiah 2, then find a installer.No use beating a dead horse!!
Last edited by Warlock; 22-10-2003 at 19:02. 
|
|
|
Threaded Mode