question about soldering the neo2

[hi-tek]

Hi, to those who have installed the neo2 modchip : To solder pin point 2, you have to remove the white cable from its socket right ?

Thanks

[Warlock]

what version of PS2 do you have 1,2,3 or 4

[hi-tek]

I have version UK 30004 but it's the same for all the models.

[afc_man]

yes you do have to remove this cable it just pulls out but when you are putting it back in the female ie the the socket has a flap which flips up to insert the cable easily(be carefull i used a small precision screwdriver) or you wont get it in i suppose this would probably be the best way to remove the cable-just gently ease the flap up look at it in very good light and you will see it latches when shut i hope this help dont blame me if you break it blah -blah blah--disclaimer but this is the way to remove this cable..

[maltloaf]

remove the cable by lifting the flap... the best way is with a fingernail ... much less intrusive than a driver ! Use your nail where the cable enters the connector and lift. Also make sure that the cable is fully home and aligned before closing the connector.