|
#1
08-11-2002, 11:28
|
|||
|
|||
|
magic 2 query. 3.3 volt solder point
can someone confirm that the 3.3 volt solder point is correct. when checked with a meter the point is goes to earth?
cheers ftm Last edited by FTM; 09-11-2002 at 06:24. 
|
| Sponsored Links |
|
#2
08-11-2002, 15:32
|
|||
|
|||
|
I use the diagrams on this fella's site ,the only thing i change is the gnd:
www.baldbouncer.co.uk
__________________
psx, ps2 andx boxes modded Dublin, Ireland [email]upmanu2000********com[/email] for info [url=http://www.pstation.co.uk/showthread.php?s=&threadid=6349]References here[/url][url=http://www.pstation.co.uk/showthread.php?s=&threadid=6349]References here[/url] [url=http://www.upmanu.com]Website here[/url]
|
|
#3
09-11-2002, 02:18
|
|||
|
|||
|
hi i cannot find diagrams for magic 2 chip on this site any other ideas? i have viewed diagrams on other sites & the same point is always shown, a small brass circle on the board but when tested with a meter this point goes straight to earth?
any help apreciated Last edited by FTM; 09-11-2002 at 02:45.
|
|
#4
09-11-2002, 05:00
|
|||
|
|||
|
check here:ftp://ftp.divineo.com/
__________________
psx, ps2 andx boxes modded Dublin, Ireland [email]upmanu2000********com[/email] for info [url=http://www.pstation.co.uk/showthread.php?s=&threadid=6349]References here[/url][url=http://www.pstation.co.uk/showthread.php?s=&threadid=6349]References here[/url] [url=http://www.upmanu.com]Website here[/url]
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
