I made a stupid mistake......help!!!!!!!

[pjclark1]

no he's not
and if you had ever opened a PS2
you would have known that!

when installing no-solder
undo 8 screws under plugs on bottem of ps2
put ps2 down on base, with u looking at front
carefully lift top up and over to right, so its upside down to right
do NOT pull ribbon cable connected to on/off button
unscrew 2 screws from memory/joypad board
put top back on, and turn PS2 upside down
put hand inside expansion port and press down
use other hand to pull plastic base off.
follow no-mod chip instructions.

use this method and u don't have to worry too
much about the on/off ribbon cable.

sorry i can't help you with where the other end of that ribbon goes, as i've never been silly enough to pull bits off
without being careful!