|
@Razor12911
Good work! Great results!
I don't understand practically anything about compression and flow methods, etc., but CIU has XTool (old Xtool, not 2019) and ZTool, and as far as I know some of the flows (I think that's it) are not supported by Xtool.
I would like to know if in this version when it is finished it will support all flows that old ZTool and Xtool support, or it will always be necessary to keep XTool + ZTool in CIU if I use XTool 2020.
It would be great to be able to remove some of the compressors from CIU.
Thank you!
|
23-05-2020, 16:36
Hybrid Mode
