Origa 1.25 Question, Charlie

[jumpstart]

Hello Civic2000,

I have chipped my PS2 with Origa and also we have the same unit (15000).
You are asking about the Q1-Q3 Connections right?
just follow the instructions for placing up the chip (you can see it the origachip.com in the ver 1.0 installation). In which Q3 is placed (soldered) in the board. Dont worry about the Q1 and Q2. Its a ceramic capacitor... there is no polarity for that one. But if you would like you can face the capacitor upside down (face --> marking of capacitor).
If you have place successfully your chip., then its time to follow the diagram of the ver. 1.12 and 1.2 Jap.
By the way on a note... you can easily solder the 8 wires (the one soldered directly in the cpu's legs) by using a thin blade (to isolate each legs). But be careful u might snap one of the legs... just dont apply too much pressure or it will break!
Hope i could help... anyway i'm planning to shoot some pics of my work.
And hopefully e-mail to users who would like it as a reference!
GAMERZ RULE!