Sucessfully modchipped my unit! (ORIGA)

[jumpstart]

Charlie (31-12-2001 20:22):
Jumpstart,

Did the 1.25 come with diagrams? Or what did you do?

I've just ordered to for a couple of 15000's I've got kicking around.

It doesn't come with diagrams when i recieved it.
I just followed the diagrams posted in www.origachip.com. But there are two diagrams(pictures) ver 1.0 and ver. 1.12/1.2 and i was sort confused since mine is ver 1.25.
What i did was e-mailed Marco and Gigi and attached those to pics... And they responded!
here's the response theyd give me:

> I just recently ordered a JAP Origachip ver. 1.25 from www.origachip.com
for my JAP PS2.
> I got an SCPH 15000 Model PS2.
> Just need some information which diagram should i follow?
> (Just wanted to know where the Chip (Origa) will be put.
> Attached are two diagrams (from origachip.com).
> 1st is vers. 1.00 and 2nd is version 1.12/1.2

Hi,

The diagrams that you have send, there are the same... P and M signal are
vcc and gnd (+ - power). If you don't want use wire and make a fast
installation, you can use the first diagram (solder directly on the board).

For more information, write me again.

Regards.

Cool huh?
That's what i call customer support!