XTool - Successor of ZTool

Edison007 · #1 31-05-2018, 10:40

Quote:

Not sure in terms of results here

It's normal, because i using differents decode methods in cls and exe. In cls i use some tricks, which allow me to get a higher speed. exe-decoder, yes, slower.

Quote:

I'll check in terms of the number of streams found by xtool vs afr

I think, that numbers of streams found is the same. But maybe in AFR the output container is more successfully made

Quote:

I wonder if there is still room for improvement.

Yep, but I'm not interested in this engine anymore.

KaktoR · #2 31-05-2018, 10:56

Quote:

Originally Posted by Edison007

Yep, but I'm not interested in this engine anymore.

So, what's your next clue?

Razor12911 · #3 31-05-2018, 11:52

Quote:

Originally Posted by doofoo24

test xtool precomp:zlib with 0.6 vs 0.8 on just cause 2

and... which is which?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Information about ZTool	78372	Conversion Tutorials	72	10-10-2019 06:27
ztool info	doofoo24	Conversion Tutorials	2	24-12-2017 22:08
ZTool (Ultimate Precompressor)	Razor12911	Conversion Tutorials	16	20-07-2017 07:56

The Following User Says Thank You to Razor12911 For This Useful Post:
ShivShubh (24-11-2019)