UltraARC for Inno Setup (Conversion Tool)

[SAM2712]

Razor! the error comes with only this type of method-
Pzlib+msc+srep+lzma not for lzma2 and 4x4 lzma and PZB v.0.42. I gain 37% ratio on a single ".forge" file of 238mb but during extraction same problem occur which is felice program cmdbench occur. There is not any bug on programs in both two but has in pzlib + lzma2 which is putted in ultraarc & cmdbench.
I also tried with PZB v.0.38
But failed during extraction

[78372]

Originally Posted by SAM2712

Razor! the error comes with only this type of method-
Pzlib+msc+srep+lzma2 and PZB v.0.42. I gain 37% ratio on a single ".forge" file of 238mb but during extraction same problem occur which is felice program cmdbench occur. There is not any bug on programs in both two but has in pzlib + lzma2 which is putted in ultraarc & cmdbench.
By using only pzlib + lzma or 4x4 lzma , no problem.
I also tried with Pzlib+msc+srep+lzma2 and PZB v.0.38
But failed during extraction

pzb 0.42, 0.38! Is this pzlib or precomp?

[SAM2712]

Not confirm ! probably razor put this for precomp version

Sorry my bad ! Check the edited message of error again.

Ok ! I check the error comes on some ".forge" files not
all .forge files so i check with both ultraarc and cmdbench. I think error comes on some files which have many media files on which msc works but w/o using pzlib , no error come. Acc. to my test pzlib + lzma works on mostly files Bcoz i test this method on 4 games which are: mad max, gta5, dirt3, project cars
BTW what's the PZB version stands for in ultraarc ?