Helping thread :)

[MCWRX]

Hi everyone. What can the problem that after using precomp, the decompression process starts very slow? I press "INSTALL" and it stays at 0% for 2-3 minutes then precomp starts. It is not very good I think. Is there any solution?

[Bulat]

Originally Posted by MCWRX

Hi everyone. What can the problem that after using precomp, the decompression process starts very slow? I press "INSTALL" and it stays at 0% for 2-3 minutes then precomp starts. It is not very good I think. Is there any solution?

it's ok - precomp is in beginning of your compression string, i.e. smth like "precomp+srep+lzma", and this means that on decompression it's last algo in the line, so all other compressora are done when precomp starts

still, you can use cls_precomp and cls_srep to make all decompressors work simultaneously

[MCWRX]

Originally Posted by Bulat

it's ok - precomp is in beginning of your compression string, i.e. smth like "precomp+srep+lzma", and this means that on decompression it's last algo in the line, so all other compressora are done when precomp starts

still, you can use cls_precomp and cls_srep to make all decompressors work simultaneously

Thanks for your response!

I've got something else - what can cause this error: Not enough memory. unarc.dll returned error code - 5. It appears for some users. It appears when files compressed with 4x4:lzma start to unpack. Yes, I know, you guys told me it's not very ok to use it but what alternatives do I have? It's really fast comparing to default compression. I personally haven't got this error, it's rare, but the fact that it exists, annoys me and I can't move on without making it clear. Have any of you got ideas?