Simple splitting and compress by DLG

[ShadowEagle]

Originally Posted by felice2011

For unpacking, you need to have the same files in the folder the that you use for the packaging.

And inno setup will do it automatically? So easy? Really?

[felice2011]

Originally Posted by ShadowEagle

And inno setup will do it automatically? So easy? Really?

All these question marks seem a mockery..
Nothing is Easy, Nothing is Hard, All is Possible..
If you have problems with my utility you can also ask, on the contrary to other problems you open new thread in the forum, someone will respond to your problems, in this thread we talk of problems and updates relevant to Split Kompressor.

[ShadowEagle]

Originally Posted by felice2011

All these question marks seem a mockery..
Nothing is Easy, Nothing is Hard, All is Possible..
If you have problems with my utility you can also ask, on the contrary to other problems you open new thread in the forum, someone will respond to your problems, in this thread we talk of problems and updates relevant to Split Kompressor.

Ok, i do understand. You created a tool, posted it and don`t help to get it work. I see no tutorial. I`ll give 1 star for bad support, most bad support i`ve ever seen.

[felice2011]

Originally Posted by ShadowEagle

Ok, i do understand. You created a tool, posted it and don`t help to get it work. I see no tutorial. I`ll give 1 star for bad support, most bad support i`ve ever seen.

I`ll stay with UltraARC!

Not need any tutorial to use my tool, if it is difficult for you to use it 'unique case your' remains well with UltraARC excellent tool for compressing, then eventually the concept of my utility and UltraArc is similar.
They are both two tools for split and data compression.
Your problem, as I understand it, that you can not decompress the method reflate in an installer with InnoSetup..
I repeat, if you want a solution for your problem, open a new thread and describe your problem.
Split Kompress and Ultra Arc are both utility for compression, problems with installers created with InnoSetup are discussed in the section of this forum, not in this thread.
Not continue to send messages not related to my utility or I will have to report you as spam.

[Razor12911]

Originally Posted by ShadowEagle

Ok, i do understand. You created a tool, posted it and don`t help to get it work. I see no tutorial. I`ll give 1 star for bad support, most bad support i`ve ever seen.

took me 4 minutes to figure out how this program works, from my perspective, this program is easier than ultra arc and it is reliable.