UltraARC for Inno Setup (Conversion Tool)

[Droppo]

on 2.2.1 Still the same problem.

Also I realized the program reads a file called session.ini which is created by the program, and it doesn't care if you change folders, parameters or anything if the file is there it will be read and will lead to the same error even it you change folder prefixes or anything else, they will be overriden and show up the same error.

Now deleting the file will let you use the program work again. Besides all that, the problem still persists, once done all the mentioned above.

So if you could please check that will be appreciated and ofcourse check that thing about session.ini

it's a total loop of chained errors

EDIT: Found the cause of the error. tries to move from and to the same folder. My FirstVolumeContent was set to what was supposed to be the final folder for disk files so the program tries to move the files from and to the same folder. I guess there should be a message warning when selecting folders or a check to do when the FirstVolumeContent and Disk 1 folders are the same moving should be ignored.

session.ini problem is still there, deleting it is just a quick workaround