Tutorial using CI 8.0.0

[mikey26]

hi revo.i remeber what cause that to crash its certain files in the structure that cause precomp to stop responding.Bamse did fill me in on this.if u look in the precomp bat file there -v aka verbose mode and pause when this crashes instead of the app closing down it will pause and at that point in cmd windows u will see where it crashed.
it should read some like this " found position at #########(whole bunch of numbers)

make a note of those numbers and add it to the precomp.bat
eg: precomp042 -intense -v -c- -i#######(the numbers u made a note off) %1
pause


if it crashes again u have to add those numbers also into the bat f file just like i mentioned above bit painfull but thats the way around it.

[KaktoR]

Hi

I have a little problem with my setup.

Everytime when the install sequence is finished (or Data3.pcf is unpacked, im not sure), i got this error

[ExtractSettings]
FreeArcFile1={src}\Data1.cab;DestDir:{app};Disk:1
FreeArcFile2={src}\Data2.cab;DestDir:{app}\Data;Di sk:1
FreeArcFile3={src}\Data3.cab;DestDir:{app}\Data;Di sk:1;PrecSrep:1

For Data3.cab i made the following steps

-4 Files archived in Data3.arc with no compression (just save with freearc)
-Used precomp 038 to pre-compress Data3.arc to Data3.pcf
-Then srep to compress the pcf file to srep file
-After this i used freearc to compress the srep file (-mx -ld800m)

I have also used the newest versions of precomp/srep but the same problem.

Any solutions ?