How to: overclock your DC

[--=FamilyGuy=--]

ok
When you overclock your DC ... the VMU now don't work properly !!!
You CANT SAVE!!!

But !! there's a trick to get them to work well !!

You need to overclock your vmu by the same ration than the DC !!

So for a DC OC'ed at 240 Mhz (20%) you'll need to OC the VMU from 6 MHz to 7.2Mhz(20%[Dùh])

You cam use aproximative Xtal rate if you can't find the exact parts( ex: 7.372Mhz will work instead of 7.2Mhz)

Just remove the Xtal in the middle on the vmu board (batery-side)
[it's 3 pin Xtal ... middle Pin is not important]

Then replace it by a Xtal of the right frequency. 2 Pin Xtal works fine

Here's a pic of the Xtal to remove:



Here's a pic of a OC'ed VMU:



You Might now Save with your vmu !!

Thanks to Doccy to have find how to OC the VMU

-=FamilyGuy=-