Protection Matrix Path of Neo?

[vedderx]

Followed the instructions exactly, step 1-3 except instead of modifying the permissions on Daemon Tools, I modified the permissions on A120

I dont have Daemon Tools installed.

[THE LEGEND]

Originally Posted by vedderx

Followed the instructions exactly, step 1-3 except instead of modifying the permissions on Daemon Tools, I modified the permissions on A120

I dont have Daemon Tools installed.

And did it work?

[Lostconfused]

Yes it works, its a pain to get it to work, but it does. And i did have to reinstal Alcohol and i did have to alter the reg again after restart.

And if you go to the forums of the game you can see all they issues that this patch caused, which was getting the game to run. But it doesnt realy have anything to do with our problems of getting it to run

[ravid]

please pepole open a thread for it we wanna talk about the prtection with the patch

[ravid]

from desperte, i used game jackel
it the far i come with is a message that saying somthing about cant audthincate(however) originl cd within time limit, try again?

any suggestions from here?

[plethaus]

I also got it to work following those instrucstion, using DT 3.47. On step 1 I had to deny all permissions or it wouldn't work.

[Xero]

The deny permissions in the reg way does work.

I un-installed Daemon Tools & Alcohol 120%. I then deleted the reg entries for both under software. I also deleted all scsi port listings excluding the one(s) not related to either program - in the hardware section. Then I reinstalled 120% and ran the same procedure as mentioned above with regedit.

Game started up.

[cr@zy_Killer]

hi,

I tried all of your advices but my game still don't want to start without putting the CD in the drive.
I tried the newest Version of Deamon Tools and mounted both Images.
Then i used SR7.Stop_1.0.
Than i used Anti-Blaxx_1.18 and selected SecuRom and the game and all that and tried to start it but it always says there there is the wrong CD/DVD insite.....what's my fault ??

[cr@zy_Killer]

E: How shall I rename the busdriver names? What should I write instead of the standards?

[Joe Forster/STA]

You can change the names of the bus drivers during the installation, I don't think you can change them afterwards. What to change them to? Any name should do.