|
|
|
#1
11-07-2005, 18:42
|
|||
|
|||
|
yeah those were a real %#$& to solder
I'll just have to try again then, is it ok to solder the QTUV and R wires to the chip directly rather than the vias? I'm guessing it is as they don't appear to go anywhere else but to the chip 
|
| Sponsored Links |
|
#2
11-07-2005, 19:36
|
||||
|
||||
|
yeah of course, thats what i did. i found it impossible to get the solder to stick to the flat copper pads. i just put them straight on the IC pins.
__________________
====ROCK STEADY====
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Matrix Infinity and PAL games on a NTSC system | p2501 | PS2 Games | 1 | 27-05-2005 21:07 |
| Matrix Infinity Chip Firmware | A03 | PS2 Games | 1 | 21-02-2005 22:39 |
| Problem with Infinity chip | xSAVAGEx | PS2 Games | 7 | 07-12-2004 20:30 |
| matrix infinity v7 install - question | err0r | PS2 Games | 6 | 10-11-2004 23:53 |
| Matrix Infinity 1.3 Coming This Weekend? | lufcfan | PS2 Games | 15 | 27-09-2004 10:42 |
Hybrid Mode
