|
|
|
#1
10-02-2005, 03:58
|
|||
|
|||
|
I know, Warlock, replacing the whole laser unit is not the problem. I just want to know (as I think the lasercell, the mirror, the coils and everything else except the bottom lens is perfectly working) if I can replace this small lens. It can be lifted out of the sled, at the sides it is fixed with small plastic or glue pieces, but it fits in the sled so tight that a replaced lens should hold without further glueing, I think. Did anyone try this and does anyone know if the bottom lens is coated?
|
| Sponsored Links |
|
#3
10-02-2005, 15:18
|
|||
|
|||
|
I don't know that I would put the effort into fixing that. Maybe if you had a dead laser laying around but even then you would still have to clean it and get your fingerprints off of it just from putting it back in place. Wasn't that how this all started? Plus you have to be careful that you don't scratch the lens. To me I would just spend the money on a new laser and not deal with all these headaches.
__________________
Mmmm gummi venus de milo
|
|
#4
10-02-2005, 15:27
|
||||
|
||||
|
I'd get rid and start over too
__________________
[SIZE=3][COLOR=orange][B][COLOR=blue]PS2, [/COLOR][COLOR=yellowgreen]XBOX[/COLOR] & [COLOR=darkolivegreen]Xbox 360[/COLOR] installs / repairs in [U][COLOR=red]West Yorkshire,[/COLOR][COLOR=red] UK[/COLOR][/U] - [COLOR=#ff0000]Nationwide Service [/COLOR][COLOR=darkorange]-[/COLOR]Please Contact me by PM for more info[/B][/COLOR][/SIZE] :) [B][SIZE=4][COLOR=#ff0000][COLOR=seagreen]360 DVD Drive Fw.[/COLOR] [COLOR=orange]Upgraded/Recovered/Restored -[/COLOR] Bad Flash? No Problem! [COLOR=blue]PM for info[/COLOR][/COLOR][/SIZE][/B] [B][SIZE=4][COLOR=#ff0000][COLOR=yellowgreen]XBOX 360[/COLOR] [COLOR=blue]v1.0[/COLOR] [COLOR=blue]- [/COLOR][/COLOR][COLOR=red]Samsung TS-H943A [COLOR=orange]w/ iXtreme 1.4 Fw.[/COLOR] :D [/COLOR][/SIZE][/B]
|
|
#5
10-02-2005, 17:35
|
||||
|
||||
|
I have never replaced the bottom lens as it appears to be glued in and getting the correct position again after removing it I would think might be difficult. I have however replaced bad coils in a KHS-400C with the good coils of a worn out KHS-400B as well as the upper laser lens and it worked great.
It might in fact be that your laser diode is crapping out on you. Give it a try, what could it hurt. Get back to us with the results.
__________________
[color=blue][size=2][b]Click[url=http://www.ps2-scene.org/forums/showthread.php?t=25770] here [/url]to view refes. Click[url=http://www.norcalmods.com/gallery] here [/url]to view install gallery[/b][/size][/color] [size=2][b][color=red]Mod chip installs and repair [/color][/b][/size] [url]www.norcalmods.com[/url] Last edited by spedmetal; 10-02-2005 at 17:38.
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Hybrid Mode
