burning 49f020T

[ihaveanosebleed]

Originally Posted by Quall999

First, make it so you can turn the chip off. A switch on the wire connecting to the d0 will do it if you don't have a way already. Just make sure those points are fully soldered to make the tsop un-write protected, turn on the xbox, switch of the modchip, and run the raincoat bios flasher to flash the onboard bios

Oooh yeah, that’s the stuff! Is there a detailed guide for that procedure anywhere?

[Quall999]

Link is what I used. Just remember, evox cannot flash the 49f020T chips. SO yo umust use raincoat flasher. It can be found at xbins. Note though, it comes with no bios, so you must put a 256k (MUST BE 256K!) bios named "bios.bin" in the root of the the program.

[wizzer]

Hmm ..

I didnt think you could flash the onboard tsop, if you booted off the LPC port ??

Maybe i need to read into this a little more...

Originally Posted by Quall999

Link is what I used. Just remember, evox cannot flash the 49f020T chips. SO yo umust use raincoat flasher. It can be found at xbins. Note though, it comes with no bios, so you must put a 256k (MUST BE 256K!) bios named "bios.bin" in the root of the the program.

[Quall999]

You may be right, I know evox doesn't support it, but raincoat and other flashers might. I have read about people hotswapping to do tsop flashes, I just assumed that they did what I said above. Load the chip, take it out (turn it off), and flash with an app.

[Quall999]

did you solder both of those points? I assume you have a 1.5 or less version too?

[wizzer]

I gave up .... i sold the x-box on with the LPC mod .. To much other stuff ongoing right now.