|
|
|
#1
18-11-2004, 05:03
|
||||
|
||||
lifting legs
 put two small razor blades eather side and heat up the leg with the soldering iron and apply Pressure to the blades at the same time the leg should lift up don't lift the leg too high or it will snap and then the fun starts
__________________
1800 AMD 1027 ddr Pioneer DVR-A07 the university of limerick chipper ps2 v10 pal+ripper2 gold (new baby) ps2 v6 pal+duo chipped by me Don’t take life too serious you’ll never get out alive! 
|
| Sponsored Links |
|
#2
18-11-2004, 10:00
|
||||
|
||||
|
I used an exacto knife. Put the blade under the leg and heat the leg with the soldering iron. While its placed gently push the leg up with the exacto. Don't leave the soldering iron on too long or you can burn the board.
 Good luck.
__________________
JPunisher
|
|
#3
25-11-2004, 13:37
|
|||
|
|||
|
I use a steel pick with the tip bent to a tiny hook shape, put the pick under the Pin and heat it up with the iron and LIFT.
__________________
Ps2 / Xbox chips installed in Ireland http://www.modchipsireland.com
|
|
#4
25-11-2004, 15:01
|
|||
|
|||
|
.... i didnt even use heat. i just used a metal wire bent into a hook, shoved it under it lifted with all my care. it came off with no force at all. mine was version 9
__________________
[B]v9 [COLOR=Blue]Matrix Infinity[/COLOR][/B]
|
|
#5
25-11-2004, 22:38
|
||||
|
||||
|
Well this is an old post of mine but I explained here how to do it and it works very well. http://www.fileforums.com/showthread.php?t=62487
__________________
[color=blue][size=2][b]Click[url=http://www.ps2-scene.org/forums/showthread.php?t=25770] here [/url]to view refes. Click[url=http://www.norcalmods.com/gallery] here [/url]to view install gallery[/b][/size][/color] [size=2][b][color=red]Mod chip installs and repair [/color][/b][/size] [url]www.norcalmods.com[/url]
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Hybrid Mode
