Hidalgo problems

[DPG Terik]

I am just now getting around to backing up this dvd and when using AnyDvd and CloneDvd2 I am getting errors right in the middle of the process and it stops. (I unforturnatly forgot to write down the errors).
I usually go straight to DVD Decriptor and it works fine and then I use CloneDvd to compress and burn.
But now I get a error with DVD decriptor.

I/O!

Device:[1:0:0]PLEXTOR DVDR PX-712A 1.04 (D (ATA)

ScsiStatus: 0x02
Interpretation: Check Condition

CDB: 28 00 00 1D A7 B0 00 00 01 00
Interpretation: Read(10:-Sector: 1943472

Sense Area: F0 00 03 00 1D A7 B0 0A 00 00 00 00 02 83 00 00 00 00
Interpretation: Servo Seek Error-Target Not Met

I have never seen this before and am not sure what it is telling me.
I have the latest version of AnyDvd and CloneDvd, and dvd decriptor.

I am using Ritek G05 media.
By the way, I tried searching anything for Hidalgo and could not find anything
I retried with CloneDVD and got the following error:
Processing error:
Data Error(cyclic redundancy check)

Thanks for the help
Terik

[DPG Terik]

Well I tried to back Hidalgo using DVD shrink also and at the same spot, (48%) I got the same error with CloneDvd.

Data Error (cyclic redundancy check)
Does anyone know what this could be.
Could it be that my dvd is bad. I will have to watch it and see I guess.
Terik

[TylerDurden]

What version of Anydvd do you have? Have you tried reading it with a different drive?





Tyler!

[DPG Terik]

Ok, I just watched the movie again and it stops at about the half way mark. So my conclusion is that my dvd is bad. I am going to see if I can get an exchange.

My AnyDvd is 4.1.0.1
It also stops on my other DVD player also.
I will try to get another one tomorrow.
Thanks for your help anyway Tyler.
Terik

P.S. I can't find anything on the dvd that looks bad on the service either. HUM!!

[TylerDurden]

Trust me guy, it happens. Ive had at least 2 bad discs in my time. Both looked perfectly fine. As soon as I got a replacement the new discs had no problems.





Tyler!

[DPG Terik]

Well I got my new replacement of Hidalgo and it plays just fine. BUT! I am getting the same error when trying to backup. In the CloneDVD log I get the error: Clone 1 TCE

I have the whole log copied but not sure what to look for. I ripped it with DVD Decrypter just fine but when I try to compress and burn (with CloneDVD2) I get the same error.
Just cant figure this one out.
HELP! LOL!
It stops at the same point everytime!
Terik

AnyDvd 4.1.0.1
CloneDvd2 2.5.3.3
Dvd Decrypter 3.5.1.0
Dvd Shrink 3.1.5.7

Update: It will play just fine in my TV dvd but will not play right in my computer. It shows the chapters in CloneDvd but does not show the previews
either.
Also the Dvd Decrypter rip was not good either. Just found that out.
Hum! Will keep trying!
Thanks again,
Terik