Matrix Infinity Install Problem

[ddee06]

Thanks for responding Lufcfan!
If I remember correctly the software version said Infinity 1.2. I will double check when I get home from work. I purchased the chip at modchipman. I hope my solution is as easy as upgrading the firmware. Will let you know how I come out.

I do not have a multimeter to test the connections. If the fw upgrade doesnt work i'll look into getting one.

Thanks Again!

[lufcfan]

No problem. I had a similar problem, only I didn't get the Infinity logo. It still may be a simple case of upgrading the flash though. Try the method I gave you above and see - and if that doesn't work, check the points on the underside of the board (I believe those are B and I)

[ddee06]

Problem fixed My SCEX & A connections were solder to the wrong sides (bad eyes) After fixing this PS2 boots fine and is now playing my backups. Thanks for all your help!

[DenniZ]

I've got allmost the same problem: I installd the chip, and it plays my original games well, but i won't play my backups, I don't get the infinity logo on boot to. But the strange thing is that the screen stays black when i remove the controller from port1
I think i've got the 'homebrew' version. But it won't even boot up the infinity manager it give me a red screen. My wires seems right: I checked it twice
so I don't know what to do anymore
I saw some pics of other people with the same chip and they used thicker wire for the 3.3v and the ground, It that absolute necessary? I will try the thicker wires tonight, but if someone got a better solution, that would be better