matrix infinity has v12 suppert

[Hull_chipper]

Cheerz for all that speed, I'm aware of that m8 but a post on ps2newz says you cant use this method for versions prior to 1.2.

Tis all hearsay at the mo but I'll obviously find out for myself l8r today lol

[TarzanBoy007]

Did you check the install diagram for the PsTwo? It looks even easier than a v5 or v7!!

There aren't any on-pin solders.... just two capacitors and a bunch of pads.
If not for the lack of hard drive (hd loader is the bomb), i might be tempted to get one.

Maybe i'll start offering my services to install chips on these new models. A relative walk in the park after my v7

[spedmetal]

Originally Posted by Hull_chipper

Cheerz for all that speed, I'm aware of that m8 but a post on ps2newz says you cant use this method for versions prior to 1.2.

Tis all hearsay at the mo but I'll obviously find out for myself l8r today lol

Right anything older from the factory with a flash older then v1.2 wont be able to booot from the mem manger, you can look at the code date on the actell its self, a number of 0411 or higher will have the v1.2 firmware. The only way to get a V1.0 to flash to v1.36 is to install it in a V1-V10 console then un-install it and re-install it in a V12. We sold out of all our stock of V1.0 long ago thank goodness.

[Hull_chipper]

Originally Posted by spedmetal

Right anything older from the factory with a flash older then v1.2 wont be able to booot from the mem manger, you can look at the code date on the actell its self, a number of 0411 or higher will have the v1.2 firmware. The only way to get a V1.0 to flash to v1.36 is to install it in a V1-V10 console then un-install it and re-install it in a V12. We sold out of all our stock of V1.0 long ago thank goodness.

Tis no major probs actually m8, with the disc in the tray, console upside down & the bottom removed I can flash & swap the chip without assemble/disassembly lol