Quick question on VIAs

[puppeteer666]

well i've only modded 4 v9s and i have never scraped the vias i use liquid flux on a q-tip.
then after that i just tine my iron and touch it to each one and the solder sticks good i then tine the wire touch tip to the wire and via for less than 3 seconds and wire is on.
have'nt had one console back so it's a pretty good connection.

[TylerDurden]

I actually use my fiberglass pen to brush off the laquer. And with a little flux (which I brush on with the wire itself) the solder bond is instantanious. To me 3 seconds is kinda long to hold your soldering pen there.



Tyler!

[lufcfan]

Cool! Thanks a lot Tyler & Puppeteer

You've just saved me a lot of time and effort!

[spedmetal]

Originally Posted by TylerDurden

I actually use my fiberglass pen to brush off the laquer.

I have actually started using the pen too and find it to work very good. But I did countless vias by just scrapping with a brand new exacto knife before I got the pen and it worked just fine. I also like to use the paste as warlock suggested as there is more control over where it goes.

Puppet you have been very lucky in not needing to remove the lacquer. I have seen vias on V9's that needed very little removal and others that there was no copper showing at all on the via. Every board has its differences even when they are the same version.

[lufcfan]

That makes things much easier for me guys, opposed to what I did

Thank you very, very much...