|
if you have cut a trace - simply scarpe the top coating off of the trace to expose a small section of copper on either side of the cut (be very gentle when doing this so more damage is not caused).
then tin both sides of the trace with some solder leave for a second and the bridge the cut with solder (or by soldering on a short length of wire.
__________________
[size=4][B][color=BLACK]ShadowKnyght[/size][/color]
[color=purple]Electronic Engineer[/color][/B]
[url=http://www.cyber-mag.com/station/ps2tips.htm][color=darkgreen]Tools, tips & suggestions[/color][/url]
[url=http://www.cyber-mag.com/station/laser.html][color=red]Laser adjust & clean guide[/color][/url]
|
09-05-2004, 18:50
Hybrid Mode
