Dc Backup Problems

[coldasice99]

Okay, I'm at THIS point of the tutorial. Basically, I resinstalled the drivers for my COM 1 and now it is working properly....must have been a driver problem before but now it can open COM 1. anyhow, here is where I am at on the tutorial from mega games:



- --- Let It RIP!! ---------------------------------------------------->

OK so now connect your DC to your PC with your cable, Done it? Good!

Now boot up your Serial/Slave image, leave it until you see the blue borders
once the borders go blue at the SEGA LIECENCE screen remove the serial/slave
and replace with your chosen GDROM, it will spin and you may here a little beep!
this simply means the DC has recognised the disk (like you didnt all know that)
and you are ready for action, now set up TeraTerm leaving the GDROM spinning in
your DC.

TeraTerm Pro, set up as follows:

Select: SETUP, SERIAL PORT and set:

Baud rate: 57600bps

Data rate: 8bit

Parity bit: None

Stop bit: 1bit

Flow Control: Hardware

Select the correct COM port and OK

Select : SETUP, TERMINAL SETTING and set:

Transmit new line: CR+LF

Select OK

Press enter in the terminal window and you should see this >.


OKay, basically, I set TT to correct settings as well as COM 1 on my computer to the correct settings as well. When I press enter....like it says to press is in the Terminal windows....I don't get the ">"

That's where I'm at. What's the deal with that dreamrip configuring everything? Where canI find it? Thank you very much for your help.
~Chris