The Hugest Xecuter2 Programmer Problem!!!!!!!!!!!!!!!!!!!!!!!

[infidelity]

I still get nothing

I even read a tutorial on flashing with evox. I used the method for flashing an xecuter 2lite. It talked nothing about hot swapping, but I know how to do it

I even edited the evox.ini file like it suggested. I put in the command that was on the site, onto the .ini file. I still get nothing

I've done two things

1. With the xecuter 2lite inside. I would boot up. Go into settings, flash bios, click the bio i want to use, it recogninzes it. Then I switch chips, then I press "Y" It begins to erase, but will not write.

2. With the xecuter 2lite inside. I would boot up, Then I would remove the chip, put in the 2.1 lite, click settings, click flash bios, click the bios I want to use. It says Unknown Flash Type. *SIGH* LIke I said. X2.1 lite SUCKS!@!@@!@@! Is there any possible thing left to do?????